WHEEL-FRONT 2713761 - Caterpillar

Illustration 1 g01450978
Table 1
Specification for 115-3696 Front Idler Gp
Item Qty Part Specification Description
1 1 7H-3171 Pipe Plug Remove the pipe plug from the front idler assembly and apply air pressure to this port. The front idler assembly should sustain 245 to 265 kPa (36 to 38 psi) air pressure for a minimum of 30 seconds. Add 380 20 mL (12.8 0.7 oz) of 8C-3703 Oil. Apply 4C-4030 Thread Lock Compound to the threads of the pipe plug and install the pipe plug.
2 2 109-0885 Duo-Cone Seal Gp During assembly, the rubber toric seals and all the contacting surfaces must be clean and dry. Prior to assembly, apply a thin film of 6V-4876 Lubricant on the mating surfaces of the metal seals. Make sure that the seals are assembled square with the bore. The rubber toric seal should not bulge and the rubber toric seal should not twist.
3 2 8F-8882 O-Ring Seal Lubricate the O-ring seals with the lubricant that is being sealed.
4 2 6Y-2266 Pin Install the pin with the slit in the range that is specified. Refer to Illustration 1 for the correct position of the pin as shown.
C - - Specified range is 40 degrees.
D - - Angle from centerline of idler shaft is 20 degrees.
5 - - Before assembly, the surface must be clean and free of protective coating.
6 - - Install the idler shaft so that the identification mark "R" is oriented toward the rear of the front idler assembly.
- - - End play in axial direction:
Minimum is 0.26 mm (0.010 inch).
Maximum is 1.26 mm (0.050 inch).