WHEEL & BRAKE GP 3569843 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@-->Type 1
Illustration 1 g01025602
Typical example (1) Rear camshaft bearing The rear camshaft bearing should be flush with the rear face of the pump housing. Tolerance ... 0.5 mm ( 0.02 inch) (2) Middle camshaft bearing ( 3412 engines) (A) Install the middle camshaft bearing to the following dimension from the front face of the pump housing. ... 175.8 0.3 mm (6.92 0.01 inch) (3) Install the front camshaft bearing to the following dimension from the front face of the pump housing. ... 0.8 0.5 mm (0.03 0.02 inch)During installation, the camshaft bearing joints must be located within area (B). Maximum angle to the left or to the right of the vertical centerline ... 10° 1° (4) Install the hollow dowel for the oil outlet to the following dimension from the bottom face of the pump housing. ... 1.5 0.3 mm (0.06 0.01 inch) (5) Install the hollow dowel for the oil inlet to a maximum dimension from the bottom face of the pump