WHEEL 3760969 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     7F-9306     Spanner Wrench     1    
C     9S-8901     Double Acting Cylinder     1    
3S-6224 Electric Hydraulic Pump Gp     1    
6H-4158 Pin     12    
7B-2499 Snap Ring     24    
1P-3052 Link     10    
6V-2052 Adapter     2    
7M-9773 Adapter     1    
7M-9772 Coupling Pin     1    
7M-9774 Coupling Adapter     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the condition of all seals and of all components. If the parts are worn or damaged, use new parts for replacement.
Illustration 1 g01309931
Typical Example
Illustration 2 g01316933
Attach a suitable lifting device to sprocket shaft (4). The weight of sprocket shaft (4) is approximately 84 kg (185 lb).
Install sprocket shaft (4) in the steering clutch case and install spanner nut (2). Do not tighten spanner nut (2) at this time.
Illustration 3 g01316931
Illustration 4 g01316934
Attach a suitable lifting device to Tooling (C). Install Tooling (C) onto sprocket shaft (4), as shown. Install sprocket shaft (4) with Tooling (C) with a force between 49,894 kg (110,000 lb) and 54,430 kg (120,000 lb).
Illustration 5 g01316933
Tighten spanner nut (2) with Tooling (A) while the pressure is still on sprocket shaft (4). Tighten the spanner nut (2) to a torque of 1016 68 N m (750 50 lb ft).
After spanner nut (2) is tightened, release the pressure on sprocket shaft (4) and remove Tooling (C) .
Illustration 6 g01316981
Use the following steps in order to fasten nut (2) .
Make a 9.34 mm (0.368 inch) hole in one of the grooves in nut (2) .
Drill the hole through the nut and to a depth of 19.1 mm (0.75 inch) into the sprocket shaft.
Install pin (1) .
Install ring (3) .End By: Install the final drive. Refer to Disassembly and Assembly, "Final Drive - Assemble".