WHEEL GP-FDR & 5583899 - Caterpillar

Installation Procedure
Make sure that the pin bores in the support are clean and free of dirt prior to the installation of the support.
Illustration 1 g00533721
Attach a suitable lifting device to support assembly (10) and install the support assembly. The weight of the support is approximately 225 kg (500 lb).
Illustration 2 g00533963
Illustration 3 g00533928
Temporarily install pin assembly (12) and spacer (13).
Illustration 4 g00533935
The total clearance of Measurement (X) between the support and the upper frame must be no greater than 1.0 mm (0.04 inch). If the total clearance is less than 1.0 mm (0.04 inch), the addition of shims between the support and the upper frame are not required. If the total clearance is more than 1.0 mm (0.04 inch), the addition of shims between the support and the upper frame are required. Once Measurement (X) has been determined, the support is ready for final installation. Remove bolt (11) and pin (12). Carefully install the hoses through support (10).
Illustration 5 g00533928
Apply 5P-0960 Molybdenum Grease to the surface of the support assembly at locations (D) and (E). Apply 5P-0960 Molybdenum Grease on pin assemblies (9) and (12). Slide shims (14) between the support assembly and the upper frame and install pin (12). Torque retaining bolt (11). ... 800 100 N m (590 75 lb ft)
Illustration 6 g00533685
Install bottom pin assembly (9). Position strap (8) and install bolts (7).
Illustration 7 g00533734
Place hoses in the original location. Install two clamps (6) and install bolts (5). Install clamp (4) and install nuts (3).
Illustration 8 g00533732
Install pin assembly (2). Install the washer and bolt (1). End By:
Install the boom. Refer to Disassembly and Assembly, "Swing Boom - Install".