WHEEL ASSEM. 5K1217 - Caterpillar

Removal Procedure
Start By:
Remove the drive wheel. Refer to Disassembly and Assembly for the correct procedure.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the hydraulic oil from the hydraulic oil tank into a suitable container. Refer to Operation and Maintenance Manual for the correct procedure.
Illustration 1 g01164399
Remove bolt (5) and bolts (4) from air intake assembly (2) .
Loosen clamp (1) and clamp (3) and remove air intake assembly (2) .
Illustration 2 g01164400
Disconnect hose assembly (6) .
Illustration 3 g01164401
Remove bolts (8) and move panel (7) out of the way.
Disconnect hose assembly (9) .
Illustration 4 g01164402
Loosen nuts (10) from both sides of hydraulic oil cooler (11) .
Illustration 5 g01164403
Loosen bolts (12). Use two people and remove hydraulic oil cooler (11) from the machine. The weight of hydraulic oil cooler (11) is approximately 35 kg (77 lb).Installation Procedure
Illustration 6 g01164403
Use two people and install hydraulic oil cooler (11). The weight of hydraulic oil cooler (11) is approximately 35 kg (77 lb). Tighten bolts (12) .
Illustration 7 g01164402
Tighten nuts (10) on both sides of hydraulic oil cooler (11) .
Illustration 8 g01164401
Connect hose assembly (9) .
Reposition panel (7) and install bolts (8) .
Illustration 9 g01164400
Connect hose assembly (6) .
Illustration 10 g01164399
Install air intake assembly (2) and tighten clamp (3) and clamp (1) .
Install bolts (4) and bolt (5) .
Fill the hydraulic oil tank with hydraulic oil. Refer to Operation and Maintenance Manual for the correct procedure.End By: Install the drive wheel. Refer to Disassembly and Assembly for the correct procedure.