WHEEL GP 7D8510 - Caterpillar

Introduction
This instruction contains adaptability and installation information for the Remanufactured Engine given in the chart that follows. Exchange of Parts
The Remanufactured Engine is built to the engine arrangement given in the chart. No modification or parts exchange is necessary if the replacement Remanufactured Engine Arrangement part number is the same as the original engine arrangement part number Some modification or parts exchange may be necessary when the Remanufactured Engine Arrangement part number is different than the original engine arrangement part number.Use the reference literature indicated when it is necessary to exchange parts between the original engine and the Remanufactured Engine. Although some parts on the Remanufactured Engine may be different from those on the original engine, an exchange may not be necessary depending upon the specific application.In some instances, it may be more advantageous to make minor modifications to the truck frame or engine mounting rails, rather than exchanging components between the Remanufactured Engine and the original engine.Before installation of the Remanufactured Engine, make sure the transmission mounting group, flywheel housing, flywheel, and vibration damper/crankshaft pulley are compatible with your application.Each Remanufactured Engine is rated at a specific horsepower (kW) at a specific rpm. The recommended Remanufactured Engine that is to be installed will not necessarily have the same exact horsepower (kW)/rpm rating as the original engine that it is replacing.If necessary the horsepower (kW) and rpm setting of the recommended Remanufactured Engine can be adjusted to the same horsepower (kW) and rpm as the original engine. Always refer to the Fuel Setting Information Library and/or the Fuel Setting and Related Information microfiche, Form SBFY1113, before making any changes to the fuel setting.For maximum life of the Caterpillar Remanufactured Engine, during the installation procedure be sure to check/inspect the following components for their condition and/or adaptability in the specific application.Miscellaneous
Remove any other components that are needed, such as starter motor, alternator, tachometer drive, water pump pulley, auxiliary drive pulley groups, etc. from the original engine for cleaning, inspection and/or installation on the Remanufactured Engine.If parts from the original engine are not in a condition that permits them to be used again, either recondition them or refer to the Parts Book for the part number of new parts.Before Shipment of Original (Old) Engine to the Factory do the Following Procedures
* Remove the drain plugs. Make sure that all coolant is removed from the engine. Do not install the plugs back in the engine.* Put the plugs in a package and use a piece of wire or some other similar material to fasten the package to the engine.* All parts removed from the new engine must be installed on the original (old) engine before the engine is returned to the factory. Sound Suppression
If the original engine has sound suppression material on the valve covers, oil pan and/or cylinder block, it is sometimes necessary, by law, to install sound suppression material on a replacement engine. It may be necessary to clean the valve covers of the old engine and exchange them