WHEEL & TIRE GP 9R2822 - Caterpillar

Illustration 7 g06273605
Rear view of the fuse panel
(E17) Fuse panel "E17" pin
Install the terminal (3) into fuse panel "E17" pin (E17).
Illustration 8 g06273645
Chassis ECM
(1) 18 AWG wire
(4) 8T-8730 Connector Socket
(B) Chassis ECM
Install connector socket (4) to J2-11 of the chassis ECM (B).
Illustration 9 g06273647
Wiring routing from fuse panel
(1) 18 AWG wire
(3) 122-4395 Terminal.
(A) Fuse panel
Illustration 10 g06273659
Rear cab connector
(1) 18 AWG wire
(5) 8T-8729 Connector Pin
(C) Rear cab connector
Run 18 AWG wire (1) from the rear of the fuse panel (A) toward rear cab connector (C) located above the rear left wiper motor. Cut to length with an approximate length of 2600 mm (8.5 ft) or more.
Crimp one terminal (3) to one end of the wire and one connector pin (5) to the other side of the wire.
Illustration 11 g06273661
Rear view of the fuse panel
(D17) Fuse panel "D17" pin
Insert terminal (3) end into fuse panel "D17" pin (D17) and connector pin (5) end into spare pin outs in rear cab connector (C).
Illustration 12 g06273688
Payload ECM ground
(1) 18 AWG wire
(6) 9G-9435 Ring Terminal
(D) Payload ECM ground terminal
Locate payload ECM ground terminal (D) behind the buddy seat. Run 18 AWG wire (1) from this payload ECM ground terminal (D) toward the rear cab connector (C). Cut to length with an approximate length of 1600 mm (5.2 ft) or more.
Attach one ring terminal (6) to one side of the wire and one connector pin (5) to the other side of the wire.
Remove the payload ECM ground terminal (D) and refit with ring terminal (6) attached as shown in Illustration 12.
Insert connector pin (5) side of the wire to rear cab connector (C).
Illustration 13 g06273693
(7) Harness
(8) Pin Connector
(4) 8T-8730 Connector Socket
Illustration 14 g06273740
Outside rear connector with harness
(1) 18 AWG wire
(4) 8T-8730 Connector Socket
(7) Harness
(9) Cable ties
(C) Rear cab connector
Illustration 15 g06274200
Cab roof rear showing cable routing and cab lifting bolt point
(7) Harness
(8) Pin Connector
A harness (8) will need to be fabricated to connect the supply and ground wires from rear cab connector (C) to the installed roof light. Cut two lengths of 18 AWG wire (1) that reach from the outside of rear cab connector (C) to the roof light. With an approximate length about 1600 mm (5.2 ft) or more that allows for routing the wire up the window and along the existing lighting cabling.Note: This procedure assumes that the roof light is already installed on the cab lifting bolt point on the rear of the cab roof. If the light is not installed in this location, adjust harness (8) length and routing accordingly.
Attach one connector socket (4) to each of the wires on the rear cab connector (C) side of the harness (8).
Attach the corresponding pin connector (7) for the installed roof light to the other end of the harness (8).
Install the two connector pins (4) of the harness (8) to rear cab connector (C). Install roof light pin connector (7) to the corresponding connector of the roof light.
Verify that the wires are properly crimped and inserted in to the connectors by performing the pull