WINCH AR-SKIDDER 3734611 - Caterpillar

Table 1
Tools Needed Qty
Electronic Service Tool 1
JERD2124
Electronic Technician (ET) (Single User License) 1
JERD2129
ET Data Subscription 1
171-4400 Communication Adapter Gp 1 The trucks that are shipped with the 184-4671 Power Train Software and without the installed bodies will have the hoist enable parameter that is set to a value of 2. Value 2 is a test mode. Value 2 will prevent the hoist cylinders from being activated. Use the following procedure to check and change the value:
The engine should not be running.
The truck should not be moving.
TOS indicator needs to be zero in order to change the parameter.
Illustration 1 g00839990
(1) Communications port for ET
Install the Electronic Technician (ET) to the communications port (1) that is located in the cab. Note: If the screen for the Hoist Enable Status does not appear, disconnect ET and reconnect ET.
Use the drop-down menu in ET in order to obtain the screen for the configurable parameters.
If the value for Hoist Enable Status is 0 or the value is 2, change the value to 1.
Remove ET.