WINCH AR-SKIDDER 4E3300 - Caterpillar

For engines that are equipped with a VTC254 turbocharger, loosely position the harnesses across the left side of the engine. Attach the harnesses according to Illustration 39.Install the Ignition Harness
Note: Handle the rail carefully. Otherwise, the rail may be damaged.
Connect the 207-4556 Conduit to the end of the rail.
Secure the rail to the brackets by using 3V-3308 Hard Washers and 0S-1594 Bolts .
Install a 127-0594 Wire between the rail and the engine block. Use a 0S-0509 Bolt in order to secure the ground wire to the block.
Illustration 40 g01063039
Hole for the conduit on the bottom of the terminal box
Connect the end of the conduit to the hole on the bottom of the terminal box.Note: You do not need to disconnect the P2 connector in order to install the terminals.
Illustration 41 g01051860
Harness side of the P2 connectorNote: The appropriate location for each terminal is identified on the end of each wire.
Insert each terminal into the appropriate hole in the P2 connector. Pull on each wire in order to verify that the terminal is fully inserted into the connector.Install the Components for the Fuel
Illustration 42 g01051341
Right side view (1) 8L-2779 O-Ring Seal (2) 8C-6868 Connector (3) 6J-2244 O-Ring Seal (4) 0S-1588 Bolt (5) 3V-3308 Hard Washer (6) 122-2083 Orifice (7) 210-5639 Tube As (8) 5P-8211 O-Ring Seal (9) 210-5638 Tube As (10) 124-9633 Clip (11) 6V-5049 O-Ring Seal (12) 6V-8636 Connector (13) 6V-8002 O-Ring Seal (14) 210-5637 Tube As (15) 9S-8752 Full Nut (16) 8M-7145 Washer (17) 0S-1591 Bolt (18) 6V-5039 Clip (19) 6V-5040 Clip (20) 9S-4191 Plug (21) 0S-1590 Bolt (22) 9D-6196 Clip (23) 9D-6197 Clip Install the components for the fuel according to Illustration 42.Install the Fuel Temperature Sensor
Illustration 43 g01051402
Right side view (1) 130-8299 Temperature Sensor Gp (2) 8L-2786 O-Ring Seal Install O-Ring Seal (2) and fuel temperature sensor (1). Tighten the sensor to the value in the engine's Specifications manual.Install the MIDS and the Interconnect Harness (If Applicable)
Install the MIDS at the appropriate location. Refer to Special Instruction, REHS1336 for information on installation of the panel.Connect the Customer's Wiring to the MIDS
Connect the customer's wiring to the MIDS. Refer to Special Instruction, REHS1336 for information on the connections for the customer.Flash the Modules
Verify that all of the engine's electrical connectors are connected. Verify that all of the harnesses are securely attached to the engine.
Apply electrical power to the engine.Note: For procedures on flashing the modules, refer to Troubleshooting, RENR5910.
Flash the following modules, if necessary:
ECM
ICSM
MIDSPrepare the Engine for Initial Start-Up
Check for diagnostic codes. Correct any codes before you continue.
Check the level of the coolant according to the engine's Operation and Maintenance Manual. Fill the system with coolant, as needed. Check for any coolant leaks and correct any coolant leaks.
Remove