WINDOW AS 3132078 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 5P-1733 Seal Locator 1
5P-1737 Bolts 3
9S-8858 Nut (Seal Installer) 1
6V-6142 Front Seal Installer 1
C 169-5464 Quick Cure Primer 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
The front and rear seals and wear sleeves have different spiral grooves in the seal. Because of this type of design, the front seal group for an engine is different from the rear seal group. If a seal group is installed on the wrong end of the engine, oil can actually be taken out of the engine instead of moving oil back into the engine.
Note: The seal and the wear sleeve must be replaced at the same time. Once the seal and the wear sleeve are separated, these components cannot be used again.Note: Do not use any type of lubricant during the installation of the crankshaft seal and wear sleeve.Note: Before installing the wear sleeve, inspect the crankshaft for scratches or any distortion on the surface of the crankshaft that may lead to an out of round condition. Use a polishing cloth and remove any imperfections on the crankshaft.Note: Install the seal with the directional arrow outward in order to show the direction of the crankshaft rotation.Note: The new seal comes with the retaining compound that is already applied to the inside diameter of the wear sleeve.
Use Tooling (C) to clean the outside diameter of the crankshaft.
Illustration 1 g01195469
Use Tooling (B) to install seal assembly (1). End By:
Install the crankshaft vibration damper and pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".