WINDOW GP-CAB 3277601 - Caterpillar

src="//c1.a2109.com/cat2/se/senr/senr1107a00054.png"> 9X4452
Rotation-viewed from drive end ... clockwiseNo load conditions at 25°C (77°F): Speed ... 3300 rpm minimumCurrent draw ... 80A maximumVoltage ... 24V(1) Torque for 1/2 - 13 terminal nuts ... 27 to 34 N m (20 to 25 lb ft)(2) Torque for 10 - 32 terminal nuts ... 2.25 .25 N m (19.912 2.212 lb in)(3) Tighten nut to a torque of ... 17.5 2.5 N m (12.87 1.84 lb ft)(4) Tighten nut to a torque of ... 1.5 0.4 N m (13.27 3.54 lb in) SolenoidCurrent consumption (draw) at 25°C (77°F): Pull-in current at 24V ... 103AHold-in current at 24V ... 19A 8C3644, 8C3649
Rotation as seen from drive end ... ClockwiseNo load conditions at 25°C (77°F): Speed (rpm) ... 5500 to 8000Current (amps) ... 50 to 85AVoltage ... 20.0V(1) Torque for terminal nuts ... 30 3 N m (22 2 lb ft)(2) Torque for screws holding nose housing to lever housing ... 20 2 N m (177 18 lb in)Clearance between pinion and housing pinion clearance) ... 8.3 to 9.9 mm (.33 to .39 in) 7T0794, 7T0795
Rotation as seen from drive end ... ClockwiseNo load conditions at 25°C (77°F): Speed (rpm) ... 5500 minimumCurrent (amps) ... 140A maximumVoltage ... 24.0V(1) Intermediate housing.(2) Bracket.(3) Torque for small solenoid terminal nut ... 2.25 0.25 N m (20 2 lb in)(4) Torque for large terminal nuts ... 30 3 N m (265.5 26.5 lb in)(5) Bolt. Tighten to a torque ... 8.5 1.5 N m (75 13 lb in)The pinion clearance is correct when the solenoid position dimension (X) is 62.50 + 0.20 - 0.50 mm (2.461 + .008 - .020 in) from intermediate housing (1). The following procedure is used to adjust the solenoid position: a. Loosen bolts (5) and move the solenoid until distance (X) is correct. Bracket (2) has elongated holes.b. Tighten bolts (5) after the adjustments is correct to a torque of ... 8.5 1.5 N m (75 13 lb in)