WINDOW GP-DOOR 3822260 - Caterpillar

Event Codes
Illustration 3 g00859762
Typical ET screenWhen an abnormal operating condition occurs, the status screen on Ca ET will indicate that there is an active event. Event codes on Ca ET are displayed in the following format:EXXXX Description of the codeThe "E" means that the code is an event code. The "XXXX" is a numeric identifier. The numeric identifier is followed by a description of the code. Active event codes are listed in ascending numerical order. The code with the lowest number is listed first. The active event code is removed from the list when the condition is no longer present.Some event codes are logged in the ECM memory. Some event codes are active only. The logged event codes are listed in chronological order. The most recent code is listed first.A logged code is cleared from memory when one of the following conditions occur:
The service technician manually clears the code.
The code does not reoccur for 1000 hours.
A new code is logged and there are already ten logged codes in memory. In this case, the oldest logged code is cleared.Note: Always clear logged event codes after investigating and correcting the problem which generated the code.Logged events are provided with an indicator which is used to record recurring or intermittent events. The data for the logged event shall include the following items: an event identifier (EID), a text description of the event, the number of occurrences of the event, a time stamp that shows the time that the event first occurred and a time stamp that shows the time that the event has most recently occurred .Note: The following table is for reference only.
Table 2
Event Codes    
Code (Level)     Description     Machine Response/Possible Cause    
E157 (1)     Engine #1 Failure to Start     Event will log after third unsuccessful start engine attempt.    
E192 (1)     Steering System Malfunction     Logged when steering wheel sensor readings differ between the Master and the Station control.    
E370 (1)     Screed Material Height Sensor Change During Operation     Material height sensor type changes while the machine is moving. Machine control assumes that previous material height sensor is installed until the machine is brought to a stop.    
E371 (1)     Operator Station Change while Machine in Motion     The selected active operator station changes while the machine is operating. Machine control assumes that previous operator station is active until the machine brought to a stop.    
E372 (1)     Machine Operating in Open Loop     Machine is operated without calibrating the propel solenoids or a failure occurs during operation causing the system to exit closed loop control.    
E373 (1)     Machine Not Stopped in Allotted Time     Machine motion still detected after operator issues stop command. If machine motion is present after a timer elapses, the event is activated and parking brake is applied.    
E374 (1)     Feeder Switches in Manual Position at Startup     Feeder, auger, or conveyor switches are in the manual position on startup.