WINDOW AS 3897523 - Caterpillar

Remove thrust washer (4), bolts (5), and plate (6) from the end of the trunnion. Remove the thrust washer that is behind plate (6) .
Illustration 3 g00292715
Fasten a suitable lifting device to rear trunnion support (3). Remove the rear trunnion support from the trunnion. The weight of rear trunnion support (3) is approximately 45 kg (100 lb).
Illustration 4 g00292716
Remove lip seal (7) and sleeve bearing (8) from the rear trunnion support.
Illustration 5 g00292717
Remove bolts (9) and trunnion (10) .Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-0520     Driver Group     1    
B     1U-8846     Gasket Sealant     1    
C     5P-0960     Grease Cartridge     1    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 6 g00292717
Apply Tooling (B) on the mating surface between trunnion (10) and the axle housing.
Install trunnion (10) and bolts (9). Tighten bolts (9) to a torque of 300 40 N m (220 30 lb ft).
Illustration 7 g00292716
Illustration 8 g00296635
Use a suitable press and Tooling (A) to install sleeve bearing (8) in the rear trunnion support.
Illustration 9 g00292718
(3) Rear trunnion support. (7) Lip seal. (8) Sleeve bearing. (10) Trunnion.Note: The seal must be installed so that the sealing lip is facing toward the outside of the rear trunnion support, as shown.
Illustration 10 g00296636
Use Tooling (A) to install lip seal (7) in the rear trunnion support.
Illustration 11 g00292715
Fasten a suitable lifting device to rear trunnion support (3). Install the rear trunnion support on the trunnion. The weight of rear trunnion support (3) is approximately 45 kg (100 lb).
Apply Tooling (C) on the two thrust washers.
Illustration 12 g00292714
Install thrust washer, plate (6), thrust washer (4), and bolts (5). Tighten bolts (5) to a torque of 570 80 N m (420 60 lb ft).
Illustration 13 g00292713
Install cover (2) and bolts (1) on rear trunnion support (3). Tighten bolts (1) to a torque of 270 40 N m (200 30 lb ft).End By: Install the oscillating axle. Refer to Disassembly and Assembly, "Oscillating Axle (Rear) - Install".