WINDOW AS 9R1645 - Caterpillar

Illustration 27 g02545005
Front Camera
This option opens the front camera sub menu of the Display 7" RLED. This option offers the next options:
Illustration 28 g02545102
Enable Front cam
Activate the front camera functionality (compulsory by law). After enabling this option you will be able to open a menu if the speed is higher than 35 km/h (21.74 mph), or equal to 0 km/h, whilst the hand brake is activated (yellow wire) or if the rear camera is activated (blue wire).
OFF Front camera off.
3C for an external camera switch, 3 camera system.
2C if a 2-4 camera cable is used, 2 camera system.
Invert Handbrake
Set the polarity of the switching wire that is connected to the hand brake switch (AUX2, yellow). Enable this option if the handbrake signal on the yellow wire is inverted.
Pulses per meter
Set the number of pulses per meter that is sent to the monitor of the tacho switching wire (AUX1, gray).
Function AUX wire
Defines the function of the AUX1 & AUX2 switching wires (gray and yellow). Select TCH for the tachometer function (Tacho to AUX1 and hand brake to AUX2) or ZOO for the camera zoom function (only available in combination with an auto focus camera). Use in this case the AUX1 & AUX2 switching wires to zoom in and out.Attention: How can we back out of the "Front Cam" menu in case we accidentally activated this?
Answer: There are two possibilities:
1. By activating the yellow wire (which is used as a handbrake signal in a front cam setup) or activated blue wire (which is used to activate the rear camera) you can be able to get into the menus again and disable the front cam setting.
2.Alternatively you can press the option button (5) for more than 15 second to de-activate the front cam setting. Default Settings
This option opens the factory defaults menu. Choose the number of the desired factory settings (1 = standard Orlaco). There are 14 possible default settings. Ask ORLACO for more information. If the option "reset default settings" is selected, the factory settings will be reset.
Warning: All user settings will be lost when the factory defaults are reset.
Illustration 29 g02545079
External device configuration
This option opens the configuration menu of an external device (if possible).
Illustration 30 g02545081
Info
Check in this screen your software version which is described in this manual.
Illustration 31 g02545082
Note: During cranking off the vehicle and a weak battery the power supply to the display could go below 11.5 VDC. If this happens, the display could start up without sufficient power supply to the camera resulting in a non-functioning camera with no image on screen. Assuming that the battery power recovered after the cranking to <11.5 VDC restart the display by pressing the on/off button to activate the display and camera.Machine Feature Alarm
The Machine Feature Audible Indicator is used to provide an audible feedback to the operator by any feature with such events as keys depressed, feature active or prompting for attention to a display.Priority
The Machine Feature Alarm will command the alarm to be on based on a first come first serve if the