WIPER GP-WINDOW 1559894 - Caterpillar

Brake Pedal
Brake Pedal - To apply the brakes and slow or stop the tractor, push the brake pedal DOWN.Use the brakes on a downgrade to keep the engine from overspeeding. Brake Pedal - To allow the tractor to move, or increase ground speed, RELEASE the brakes.Governor and Decelator
Governor Lever (1.) - For higher engine RPM, pull the lever BACK toward the operator. To slow the engine, push the lever FORWARD. For low idle, push the lever FORWARD to the detent position. To shut off the engine, push the lever all the way forward through the detent. Decelerator Pedal (2.) - To override the governor control and reduce the engine speed, Push DOWN on the pedal. Use the pedal for directional shifts.Steering Clutch/Brake Control
There are two steering clutch/brake control levers. The lever on the left, controls the left steering clutch and brake. The lever on the right controls the right steering clutch and brake. Left Steering Clutch/Brake Lever (1.) - To steer the tractor to the left, pull the left lever (1) BACK. The rate of steering is controlled by how far the lever is pulled back.When a slight lever pressure is felt while pulling it back, the lever will be entering the braking position.To brake the left track for a pivot turn, pull the lever all the way back.Pulling the left lever all the way back will NOT stop the tractor. Right Steering Clutch/Brake Lever (2.) - To steer the tractor to the right, pull the right lever (2) BACK. The rate of steering is controlled by how far the lever is pulled back.When a slight lever pressure is felt while pulling it back, the lever will be entering the braking position.To brake the right track for a pivot turn, pull the lever all the way back.Pulling the right lever all the way back will NOT stop the tractor.Parking Brake Lock Lever
Parking Brake - This lever engages the parking brake and locks the transmission lever in neutral. The tractor should not move when engaged. Unlocked - To release the parking brake, pull the lever UP. Locked - To engage the parking brake, PUSH the lever DOWN. This will also lock the transmission LEVER in NEUTRAL.Transmission Speed Control Lever
Transmission Speed Control Lever - This lever controls transmission neutral, forward, reverse and three speeds forward or reverse. Move the lever to the desired direction and speed.Bulldozer Blade
Float (1.) - For blade float, push the lever all the way FORWARD into detent. In this position, the blade will move up and down following the ground contour.The lever will remain in the float position (detent) until manually pulled out of detent position. The lever will then return to HOLD. Lower (2.) - To lower the blade, push the lever forward. Release the lever and it will return to HOLD. Hold (3.) - Release the lever from raise or lower, and it will return to HOLD. The blade movement will stop. Raise (4.) - To raise the blade, pull the