WIPER GP-WINDOW 2378116 - Caterpillar

Table 1
GPS Status Message     Problem     Solution    
"Low Accuracy (Move)"     The machine does not have an AS400 angle sensor configured for blade pitch.     Move the machine
3.05 m (10.0 ft).
Configure an AS400 angle sensor or the blade pitch.    
"No GPS Receiver Data"     There has been no GPS data coming from one or both GPS Receivers for at least 1.5 seconds.
This could be caused by:
a problem with a GPS Receiver
a cabling fault, or a problem with a GPS Receiver configuration.     Check the cable, power, and connections. Check the physical condition of the GPS Receivers.
Turn off the Display and then turn the Display back on.
If problems continue, contact your Site Manager.    
"No GPS Data (Right)"     Accurate positions are being generated for the left GPS Receiver but not for the right.
This could be caused by a cabling fault, or a problem with the GPS Receiver configuration.     Check the cable, power, and connections for the right receiver.
If problems continue, contact your Site Manager.    
"Low Accuracy (GPS)"     The GPS error estimate has exceeded the limit set by the GPS Accuracy Mode.     Change your GPS Accuracy Mode.
Check the data radio and radio cable.
Consult your Site Manager to adjust the accuracy limits.    
"V.Low Accuracy (GPS)"     The AccuGrade System is receiving autonomous GPS positions from one or both GPS Receivers.     Check the data radio and base station.    
"Old Position"     A position is not being generated by one, or both, GPS Receivers     Check the GPS Receivers and cables.    
"Invalid GPS Configuration"     There is a problem with a GPS Receiver output configuration. The coordinate system may be missing from a GPS Receiver configuration.
There is a GPS data but the data is in the wrong format, or the baud rate is incorrect.     Load a design. Doing so will send a valid GPS configuration file to the GPS Receivers. Alternately, see your Site Manager.    Table 2 lists messages that relate to general operation of the AccuGrade System.
Table 2
Flashing Message     Reason     Solution    
"Avoid Zone Entered"     You have entered an Avoidance Zone. This is an area that has been designated as hazardous or otherwise undesirable for machine operation.     Use Plan View in order to guide your machine out of the Avoidance Zone.    
"Loading Data"     The Display is loading the current design information.     Wait for the message to stop. The message will disappear after a short period of time.    
The Display is loading the Layered Lift surface.
"Check Machine Type"     The stored machine settings are invalid.     Restore the correct machine settings file.    
Ask the site manager to correct the system configuration. Table 3 lists the automatic controls messages relating to the AccuGrade System.
Table 3
Message     Indicates     Solution    
"No Design Loaded"     No design is loaded.
The previously loaded design may not be on the data card.
The card has been removed while the file is loading.     Load a design,