WIRE, PUSH PULL 0991485 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
C(1) 132-8772 Seal Locator 1
D(1) 1U-7596 Bolt 2
E(1) 1U-7597 Sleeve Ring 1
F(1) 1U-7594 Seal Installer 1
G(1) 9S-8858 Nut 1
(1) Part of the 1U-7598 Seal Installer
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Ensure that the rear of the crankshaft is thoroughly clean and dry prior to the installation of the crankshaft rear seal.
Illustration 1 g01003875
Fasten Tooling (C) to the rear of the crankshaft with Tooling (D). Hand tighten Tooling (D).
Position the crankshaft rear seal and crankshaft rear sleeve (1) on Tooling (C). Position Tooling (E) on Tooling (C).
Illustration 2 g01003866
Typical example
Position Tooling (F) over Tooling (C) and Tooling (E). Install Tooling (G). Tighten Tooling (G) in order to install the crankshaft rear seal and the crankshaft wear sleeve.
Remove Tooling (G), Tooling (F), and Tooling (E). Turn over Tooling (E). Install Tooling (E), Tooling (F), and Tooling (G). Tighten Tooling (G) in order to complete the installation of the crankshaft rear seal and the crankshaft wear sleeve.
Remove Tooling (G) and Tooling (F). Check Tooling (E) and Tooling (C). The faces of Tooling (E) and Tooling (C) will be flush if the crankshaft rear seal and the crankshaft wear sleeve are properly installed. Refer to the Specifications module for more information.
Remove Tooling (E), Tool (E), and Tooling (C). End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".