WIRE AS 2044311 - Caterpillar

****Affected Product****
Refer to the attached Rework Procedure.
It is recommended, that REBE8803, Service Letter, "PRODUCT SUPPORT PROGRAM FOR REWORKING THE GEARBOX BRACKET ON CERTAIN 924K, 930K, AND 938K WHEEL LOADERS", be performed at the same time as this Rework Procedure.
**Please retain removed parts for a period of 30 days before discarding.
OWNER NOTIFICATION
U.S. and Canadian owners will receive the attached Owner Notification.
SERVICE CLAIM ALLOWANCES
****Parts Stock****
Submit one claim for all parts removed from dealer parts stock.
****Affected Product****
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 1.0-hour job
PARTS DISPOSITION
****Parts Stock****
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
****Affected Product****
**Please retain removed parts for a period of 30 days before discarding.
COPY OF OWNER NOTIFICATION FOR U.S. AND CANADIAN OWNERS
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR REPLACING THE ATAAC HOSES ON CERTAIN WHEEL LOADERS
MODELS INVOLVED - 924K, 930K, and 938K Wheel Loaders
Dear Cat Product Owner:
The air to air aftercooler (ATAAC) hoses need to be replaced on the products listed below. The existing hoses can fail. You will not be charged for the service performed.
Contact your local Cat dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
Please refer the dealer to their Service Letter dated 12Oct2012 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 12Oct2012 Service Letter
Rework Procedure
1. Remove and discard the two existing 4N-6749 Hoses located in the 332-3641 Air Lines Group. Retain the 144-0367 Hose Clamps for later re-use in this Rework Procedure. Refer to Image1.1.1.
Image1.1.1
2. Install two new 4N-6749 Hoses with the 144-0367 Hose Clamps. Tighten the 144-0367 Hose Clamps to a specified torque of 11 +/- 1 N.m.