WIRE AS. 3096082 - Caterpillar

Illustration 3 g01383474
Rear of Generator (4) Right screed extension heating element (GFCI circuit breaker) (5) Right main screed heating element (GFCI circuit breaker) (6) Left main screed heating element (GFCI circuit breaker) (7) Left screed extension heating element (GFCI circuit breaker) (8) Main circuit breaker for auxiliary power panel (no GFCI)The generator circuit breaker panel is located on the rear of the generator set. The panel is under a hinged access panel. The panel contains the following circuit breakers:
Circuit breaker (4) for the heating element on the right screed extension
Circuit breaker (5) for the heating element on the right main screed plate
Circuit breaker (6) for the heating element on the left main screed plate
Circuit breaker (7) for the heating element on the left screed extension
Main circuit breaker (8) Main circuit breaker (3) protects generator power panel. The following circuit breakers are ground fault protected devices: circuit breaker (8), circuit breaker (4), circuit breaker (5) and circuit breaker (6). These circuit breakers are used when the machine is equipped with an electric screed heater.
Illustration 4 g01383485
Front of Generator (9) Hydraulic generator relayHydraulic generator relay (9) is located on the left side of the machine. The relay is in front of the generator. The coil of the relay receives power from the auxiliary circuit breaker. Terminal "J2-9" of the machine ECM provides a ground signal to the relay coil when the generator control switch is in the ON position.When the coil of hydraulic generator relay (9) is energized, power is transferred from the auxiliary circuit breaker to the generator hydraulic solenoid. When the hydraulic solenoid is energized, hydraulic oil is directed from the generator pump to the generator motor.
Illustration 5 g01383486
Rear of Generator (10) Generator relayGenerator relay (10) for the belt driven generator is located on the rear side of the generator. The rear panel provides access to this component.The coil of generator relay (10) receives power from the auxiliary circuit breaker. Terminal "J2-9" of the machine ECM provides a ground signal to the relay coil when the generator control switch is in the ON position. When the coil is energized, the generator relay closes. This action connects terminal "E+" on the generator terminal board to terminal "E+" on the generator circuit board. When the relay is energized, excitation current is provided to the generator armature, and the generator provides voltage to the generator panel.
Illustration 6 g01383488
Compartment at Front of Operator Station (11) Machine ECM (12) Connector "J2 " (13) Connector "J1"Machine ECM (11) is mounted to the door of the compartment at the front of the operator station. The compartment door provides access to this component.Machine ECM (11) controls the generator system. This ECM has two 70-pin connectors, connector "J1" (13) and connector "J2" (12) .Machine ECM (11) communicates with the left operator control unit and the machine ECM through the Cat Data Link and the controller area network (CAN). The Cat Data Link is a proprietary communication standard that was developed by Caterpillar Inc. The Cat Data Link requires a positive