WIRE AS 3183132 - Caterpillar

Removal Procedure
Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove filler cap slowly to relieve pressure only when engine is stopped and radiator cap is cool enough to touch with your bare hand.Cooling System Conditioner contains alkali. Avoid contact with skin and eyes.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00712486
Remove three bolts (1), six washers and three nuts.
Illustration 2 g00712487
Support coolant tank (2). Carefully unscrew cap (3) and drain the coolant from the coolant tank into a suitable container.
Illustration 3 g00712488
Loosen hose clamp (4) in order to disconnect hose (5) from the underside of coolant tank (2). Remove coolant tank (2) .Installation Procedure
Illustration 4 g00712486
Install coolant tank (2) with three bolts (1), six washers and three nuts.
Connect hose (5) to the underside of coolant tank (2) with hose clamp (4) .End By: Fill the cooling system with coolant to the correct fluid level. Refer to Operation and Maintenance Manual, "Cooling System Level - Check" for more information.