3C8402 WIRE AS Caterpillar parts
Rating:
Alternative (cross code) number:
CA3C8402
3C-8402
3C8402
CA3C8402
3C-8402
3C8402
Weight: 0.14 pounds 0 kg.
For full view, you need register
Information:
Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-7600 Slide Hammer Puller 1
B - Pry Bar 1
C 5P-7312 Seal Distorter 1
D 5P-7314 Distorter Ring 1 Start By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Ensure that the rear gear remains in place when the crankshaft rear seal and crankshaft wear sleeve are removed.
Install two bolts from the flywheel and suitable washers through the rear gear in the crankshaft.
Illustration 1 g01187206
Note: Ensure that you do not damage the flywheel housing with Tooling (B) .Note: If the crankshaft wear sleeve starts to slide off the crankshaft, go to Step 3.
Use Tooling (B) to pry around the lip of crankshaft wear sleeve (2) .
Use Tooling (A) or a punch and hammer in order to puncture three or more holes in crankshaft rear seal (1) .
Use Tooling (A) to remove crankshaft rear seal (1) .
If necessary, use Tooling (C) and Tooling (D) to remove crankshaft wear sleeve (2) .
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-7600 Slide Hammer Puller 1
B - Pry Bar 1
C 5P-7312 Seal Distorter 1
D 5P-7314 Distorter Ring 1 Start By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Ensure that the rear gear remains in place when the crankshaft rear seal and crankshaft wear sleeve are removed.
Install two bolts from the flywheel and suitable washers through the rear gear in the crankshaft.
Illustration 1 g01187206
Note: Ensure that you do not damage the flywheel housing with Tooling (B) .Note: If the crankshaft wear sleeve starts to slide off the crankshaft, go to Step 3.
Use Tooling (B) to pry around the lip of crankshaft wear sleeve (2) .
Use Tooling (A) or a punch and hammer in order to puncture three or more holes in crankshaft rear seal (1) .
Use Tooling (A) to remove crankshaft rear seal (1) .
If necessary, use Tooling (C) and Tooling (D) to remove crankshaft wear sleeve (2) .