AVSPARE.COM
parts catalog

WIRING KIT 0876886 - Caterpillar



0876886 WIRING KIT Caterpillar parts WIRING
Rating:
36
Alternative (cross code) number:
CA0876886
087-6886
0876886
Caterpillar 0876886 WIRING KIT

Buy WIRING KIT 0876886 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


To maintain proper machine control and effective hydrostatic braking on downhill slopes over 6%, this machine must be operated in Low Range (L). Failure to follow these instructions could result in an overspeed condition, loss of control and/or sudden stopping by the secondary (emergency) braking system which could cause serious injury or death.
Note any needed repairs during machine operation. Report any needed repairs.Lower the rotor. Slowly propel the machine when you start a cut. This operation prevents the machine from riding up on the rotor and lunging backward. This operation also prevents excessive bouncing.Do not allow anyone to stand or walk behind the machine while the machine is in operation. The machine may lunge backward if the rotor hits an obstruction.Carry attachments approximately 40 cm (15 inches) above ground level. Do not go close to the edge of a cliff, an excavation, or an overhang.If the machine begins to sideslip downward on a grade, immediately remove the load and turn the machine downhill.Avoid any conditions that can lead to tipping the machine. The machine can tip when you work on hills, on banks and on slopes. Also, the machine can tip when you cross ditches, ridges or other unexpected obstructions.Avoid operating the machine across the slope. When possible, operate the machine up the slopes and down the slopes.Maintain control of the machine. Do not overload the machine beyond the machine capacity.Be sure that the hitches and the towing devices are adequate.Only connect the trailing equipment to a drawbar or to a hitch.Never straddle a wire cable. Never allow other personnel to straddle a wire cable.Before you maneuver the machine, make sure that no personnel are between the machine and the trailing equipment. Block up the hitch of the trailing equipment in order to align the hitch with the drawbar. Maneuver the machine. Connect the machine to the trailing equipment.Know the maximum dimensions of your machine.Limiting Conditions and Criteria
Limiting conditions are immediate issues with this machine that must be addressed prior to continuing operation.The Safety Section of the Operation and Maintenance Manual describes limiting condition criteria for replacing items such as safety messages, seat belt and mounting hardware, lines, tubes, hoses, battery cables and related parts, electrical wires, and repairing any fluid leak.The Maintenance Interval Schedule in the Operation and Maintenance Manual describes limiting condition criteria that require repair or replacement for items (if equipped) such as alarms, horns, braking system, steering system, and rollover protective structures.The Monitoring System (if equipped) described in the Operation Section of the Operation and Maintenance Manual provides information on limiting condition criteria, including a warning level that requires immediate shutdown of the machine.


Parts wiring Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.