WIRING GP-CAB 1067778 - Caterpillar

1. Remove bolts (1) and the washers that hold the valve cover to the inlet manifold. Remove the valve cover and gasket.2. Remove the gasket from the valve cover. The following steps are for the installation of the valve cover and gasket.3. Be sure the mating surface of the valve cover and the inlet manifold is thoroughly clean. Apply 8T9021 Depend No-Mix Adhesive to the mating surface of the valve cover between each mounting bolt hole. Position a new valve cover gasket in the valve cover.
3114 Valve Cover Tightening Sequence
3116 Valve Cover Tightening Sequence4. Put the valve cover in position on the inlet manifold. Install the bolts and washers that hold it.5. Tighten the bolts in the number sequence shown in the appropriate illustration to a torque of 8 3 N m (72 27 lb in).End By:a. install air cleaner group