WIRING GP-ENGINE 1365919 - Caterpillar

1. Remove the six rocker shaft assembly mounting bolts (1).2. Remove the rocker shaft assembly (2).3. Remove the push rods (3).Install Rocker Shaft Assembly And Push Rods
1. Install the push rods.2. Coat the rocker shaft assembly mounting bolt threads with 9M3710 Anti-Seize Compound.3. Position the rocker shaft assembly on the engine, and install the mounting bolts and washers.
The dowels pins (1) on each end of the rocker shaft assembly must align with the holes (2) in the cylinder head assembly. If the pins and holes are not aligned when tightening the rocker shaft assembly, damage to the rocker shaft assembly will result.
Tighten the bolts 1, 2, 3, 4, 5, and 6 in numerical order to 115 lb. ft. (15,9 mkg). Retighten the bolts in numerical order to 175 5 lb. ft. (24,2 0,7 mkg). Finally, retighten again (hand torque only) in numerical order to 175 5 lb. ft. (24,2 07, mkg).4. Adjust the inlet valve clearance to .015 in. (0,38 mm) and exhaust valve clearance to .025 in. (0,64 mm).concluding step: a) install valve cover