WIRING GP-SENSOR 1472954 - Caterpillar

Removal Procedure
Start By:
Remove the load control valve. Refer to Disassembly and Assembly, "Load Control Valve (Frame Leveling Cylinder) - Remove and Install".
Illustration 1 g00946516
Remove solenoid valve (1) from load control valve (2) .
Illustration 2 g00946517
Remove two backup rings (3), O-ring seal (4), two backup rings (5), O-ring seal (6), two backup rings (7), O-ring seal (8) and O-ring seal (9) from Solenoid valve (1) .
Remove fastener (11) in order to remove two coils (10) .Installation Procedure
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Illustration 3 g00946517
Install two coils (10) and fastener (11) onto solenoid valve (1). Tighten the fastener to a torque of 6 1 N m (4.4 0.7 lb ft).
Install O-ring seal (9), O-ring seal (8), two backup rings (7), O-ring seal (6), two backup rings (5), O-ring seal (4) and two backup rings (3) onto solenoid valve (1) .
Illustration 4 g00946516
Install solenoid valve (1) into load control valve (2). Tighten the solenoid valve to a torque of 45 6 N m (33 5 lb ft).End By: Install the load control valve. Refer to Disassembly and Assembly, "Load Control Valve (Frame Leveling Cylinder) - Remove and Install".