WIRING GP-CAB TILT 2035419 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01217457
Disconnect hose assemblies (1). Loosen bolts (2) in order to disconnect harness assemblies (3) .
Remove bolts (4). Remove engine electronic control (5) .Installation Procedure
Note: Cleanliness is an important factor. Before the installation procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 2 g01217457
Position engine electronic control (5) and install bolts (4) .
Connect harness assemblies (3). Tighten bolts (2) to a torque of 6 1 N m (53 9 lb in). Connect hose assemblies (1) .