WIRING GP 2058281 - Caterpillar

Illustration 23 g00541048
Place a suitable sling around tilt cylinder (8) . Fasten the suitable sling to a hoist. Position the tilt cylinder for installation of the pin.
Illustration 24 g00617462
Use Tooling (B) to install pin (13) . Center the pin axially. The weight of the pin is 55 kg (120 lb).
Illustration 25 g00544967
Illustration 26 g00545225
After 50 hours of operation, tighten the collet bolts to 1800 200 N m (1330 150 lb ft). Failure to tighten the collet bolts may result in damage to the machine.
Thoroughly clean the inside and outside of collets (10) and (12) (not shown). Apply 5P-3931 Anti-Seize Compound to the inside and outside of collets (10) and (12) (not shown) prior to assembly. Center collets (10) and (12) (not shown) in the bores.
Apply 5P-3931 Anti-Seize Compound to the threads of bolt (9) . Install bolt (9) , the washers, and the nut into collets (10) and (12) (not shown). Perform the following steps in order to properly install the collets:
Use Tooling (C) in order to tighten the bolt to a torque of 1800 200 N m (1330 150 lb ft).
Sufficiently strike the collets with a hammer in order to cause the torque to drop to less than 950 N m (700 lb ft).
Use Tooling (C) in order to tighten the bolt to a torque of 1800 200 N m (1330 150 lb ft).
Sufficiently strike the collet with a hammer in order to cause the torque to drop to less than 1600 N m (1180 lb ft).
Use Tooling (C) in order to tighten the bolt to a torque of 1800 200 N m (1330 150 lb ft).
Illustration 27 g00581923
Connect hose assembly (11) .
Repeat Step 31 through Step 36 for the remaining tilt cylinder.
Illustration 28 g00545298
Position link and bearing assembly (3) for installation. The weight of the link and bearing assembly is 559 kg (1230 lb).
Place a suitable lifting sling around pin assembly (4) . Attach the other end of the suitable lifting sling to a hoist. Install pin assembly (4) . The weight of the pin assembly is 74 kg (162 lb).
Illustration 29 g00540978
Install O-ring seal (6) on pin assembly (4) .
Illustration 30 g00532364
Install bolt (5) , the washer, and the spacer.
Illustration 31 g00545268
Install plate (2) . Install three bolts (1) and the washers.
Illustration 32 g00545275
Illustration 33 g00545282
Remove O-ring plug (48) and the O-ring seal from link and bearing assembly (3) .
Add 250 cc (15.3 in3) of 2P-9863 Lubricant to the pin assembly. Use Tooling (E) in order to check the air void after adding the lubricant. Use the 30 cc (1.8 in3) calibration tube that is included with the tooling in order to calibrate Tooling (E) . The air void must be between 25 kPa (3.5 psi) and the measurement that was obtained with the 30 cc (1.8 in3) calibration tube. Add or subtract lubricant in order to achieve the correct pressure reading from Tooling (E) .
After the air void is correct and the correct amount of 2P-9863 Lubricant has been added, install O-ring plug (48) and the O-ring