WIRING GP-ENGINE 2350107 - Caterpillar

"The Svd File Is An Obsolete Version. Please Regenerate It Using Sitevision Office V5.50"
The system will not load the version 1.0 *.svd files. Consult the provider of the data. Your provider of the data will need to send the design surfaces to the data card again."There Is A Problem With The Data Card - Please Insert A Valid Card. Check The Program Log For Details."
The Display cannot read any data from the data card. You will not be able to load any designs from the data card.Remove the data card and reinsert the data card into the Display correctly. If this still fails, contact your Site Manager."Warning: Your Gps Base Station Coordinates Have Changed. Continued Operation May Give Bad Results."
The base station may have been moved. Guidance may be wrong. Do not continue operation until your Site Manager has checked the coordinates of the base station."Your Gps Base Station Coordinates Have Changed"
The base station has moved since you have last used the AccuGrade System. This means that a change in the values for the position of the base station has been detected.Contact your Site Manager immediately in order to check the coordinates of the base station. Continued operation may cause bad results."Your GPS Receiver Is Not Responding Correctly"
The Display is not receiving the expected responses from the GPS Receiver.Try the following:
Check the cable connections to the GPS Receiver.
Check the "Diagnostics" dialog and "Diagnostics - GPS" dialog in order to see if the GPS Receiver is responding.
Switch off the power for the machine, and then switch the power for the machine back on.Errors And Warning Messages For Map Recording
If map recording is enabled, the following error messages can appear if map recording stops."Corrupt File Or Data Card"
Contact your Site Manager in order to repair the data card."Data Card Full"
Contact your Site Manager in order to clear the data card of unnecessary files."No Data Card Present"
Map recording cannot be activated if there is no data card in order to record the mapped information. If you were recording map data, the recording has automatically stopped. If necessary, insert the data card correctly in the slot. Turn on map recording in order to continue logging data."Read/Write Error"
Contact your Site Manager in order to check the program log and data card for errors."Unexpected Error"
Contact your Site Manager in order to check the program log and data card for errors.Errors And Warning For Automatic Controls
The following error messages may be displayed by a AccuGrade System that is equipped with automatic controls and the automatic controls is enabled."As400 (Pitch) ..."
The Angle Sensor has reported a fault. Faults may occur while the Angle Sensor updates its settings during, or immediately after, a firmware update or pitch calibration.Try one of the following:
Wait two minutes for the settings to take effect
Check all cable connections
Check that all devices are responding.If problems persist, contact your dealership's Technical Communicator for a possible consultation with Caterpillar."No Controls Data Is Being Received. Please Check The Cable Connections"
No automatic controls data is being received