WIRING GP-ELECTRONIC CONTROL 2358203 - Caterpillar

Removal Procedure
Turn the fuel supply to the OFF position and turn the power disconnect switch to the OFF.
Illustration 1 g02138690
Typical Example
Disconnect fuel line (1) from both ends.
Illustration 2 g02140391
Typical Example
Disconnect solenoid harness (2) .
Illustration 3 g02139134
Remove bolts (3) from the manifold.
Illustration 4 g02139144
Remove manifold (4) .
Illustration 5 g02138698
Remove locknuts (5) .
Illustration 6 g02139150
Write down the polarity and remove wires (6) from the terminal studs. The polarity is designated by "+" and "-" signs around the terminal studs.
Illustration 7 g02139164
Remove seal (7) .
Illustration 8 g02139169
Remove pump assembly (8).
Illustration 9 g02167735
Remove backup rings (9), seal (10), and seal (11) from the pump assembly.Installation Procedure
Install the fuel priming pump in the reverse order of removal.
Illustration 10 g03381244
Proper orientation of the new fuel priming pump.
Use the pump seal installer that is provided in the pump kit to press in the pump assembly (8) and seals.Note: The outlet of the pump should be at the top center position.
Install new locknuts (6). Torque locknuts to 1.3 N m (12 lb in).
Torque bolts (3) to 12 3 N m (106 27 lb in).
Use two people in order to flush the fuel pump and fuel line (1) into a suitable container for disposal. The fuel pump can be activated by turning on the key or pressing the manual switch. The manual switch, if available, is located on the primary fuel filter base.