WIRING GP-CAB 2365239 - Caterpillar

Installation Procedure
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g01100364
Attach a suitable lifting device to eyebolt (14). The weight of transmission hydraulic control valve (18) is approximately 50 kg (110 lb). Install transmission hydraulic control valve (18) to the transmission.
Install four bolts (17) to transmission hydraulic control valve (18). Tighten bolts (17) to a torque of 48 4 N m (35 3 lb ft).
Install wiring harness (15) to the transmission case.
Install nut (16). Tighten nut (16) to a torque of 9 1 N m (80 9 lb in).
Illustration 2 g01050354
Install O-ring seals (13) to sleeves (12).
Illustration 3 g01050355
Install sleeves (12) through the transmission case and into the transmission hydraulic control valve.
Install the bolts that hold sleeves (12).
Illustration 4 g01050343
Install the O-ring seals into manifold (7). Place the manifold in position on the transmission. Install the bolts that hold the manifold in position.
Install the gasket and cover assembly (11). Install the bolts and washers that hold the cover in position.
Connect four hose assemblies (5), (8), (9) and (10).
Connect electrical connector (4) and electrical connector (6).
Illustration 5 g01062033
Install tube assembly (3).
Illustration 6 g01050344
Install bracket assembly (2).
Illustration 7 g01050350
Install cover (1).