AVSPARE.COM
parts catalog

WIRING GP-REAR 2443967 - Caterpillar


2443967 WIRING GP-REAR Caterpillar parts
Rating:
71
Alternative (cross code) number:
CA2443967
244-3967
2443967
Caterpillar 2443967 WIRING GP-REAR

Buy WIRING GP-REAR 2443967 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Disassembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     175-5507     Nitrogen Charging Group     1    
B     1P-2853     Spanner Wrench     1    Start By:
Remove the steering accumulator. Refer to Disassembly and Assembly, "Steering Accumulator - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: The accumulator contains nitrogen gas that is under high pressure. Do not attempt to disassemble the accumulator until the pressure has been released.
Personal injury can result from the sudden release of high pressure oil.Be sure the engine has been shut off for a minimum of five minutes to ensure that the accumulator pressure is zero.The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or the cap from the top of the accumulator.
Before the disassembly procedure, use Tooling (A) in order to verify that accumulator (1) is completely discharged.
Illustration 1 g01183788
Remove plug (2) .
Use Tooling (B) in order to remove nut (3). Remove spacer (4) .
Illustration 2 g01183805
Push fitting (5) into accumulator shell (6) .
Illustration 3 g01183808
Remove washer (7). Remove O-ring seal (8). Remove ring (9) ..
Illustration 4 g01183810
Fold ring (10) in half in order to remove ring (10) from accumulator shell (6) .
Illustration 5 g01183811
Remove fitting (5) from accumulator shell (6) .
Illustration 6 g01183817
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove nut (11). Remove sleeve (12). Remove spring (13). Remove poppet (14) from fitting (5) .
Illustration 7 g01183823
Remove nut (15).
Remove seal (16) .
Remove valve assembly (17) .
Remove nut (18) .
Illustration 8 g01183832
Remove bladder (19) from accumulator shell (6) .


Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.