WIRING GP-LUBRICATION 2501096 - Caterpillar

General
Do not allow unauthorized personnel on or near the engine while it is being serviced.Do not wear loose clothing and jewelry whenever working around engines or machine.Stop engine before making adjustments or repairs to the engine or driven equipment unless specified otherwise.Attach a "DO NOT OPERATE" or similar warning tag on the start switch, or start button, before servicing the engine. These tags, Form SEHS7332, are available from your Caterpillar dealer.Be sure the remote starting system is inoperative on engine being serviced. Remove the starter key.Disconnect and tape the battery ground lead before working on an engine to prevent accidental starting.To prevent injury, install guards over all exposed drive shafts, pulleys or any application with exposed rotating parts.Relieve all pressure in air, oil, fuel or water systems before any lines, fittings or related items are disconnected or removed. Be alert for possible pressure when disconnecting any device from a system that utilizes pressure. Do not check for pressure leaks with your hand.Use caution when removing cover plates. Gradually loosen (do not remove) the last two bolts or nuts located at opposite ends of the cover or device. Pry cover loose to relieve any spring or other pressure, before removing the last bolts or nuts.Always use tools that are in good condition and be sure you understand how to use them before performing any service work. Remove all tools, electrical cords and any other loose items from the engine before starting.Wear a hard hat, face shield, clothing, shoes, respirator or other protective items when necessary.When using pressure air, wear protective glasses and protective clothing.Wear ear protective devices to prevent hearing damage, if working inside an enclosed engine room with engine running.Fire or Explosion Prevention
Fire may result from lubricating oil or fuel sprayed on hot surfaces causing personal injury and property damage. Inspect all lines and tubes for wear or deterioration. They must be routed, supported or clamped securely. Tighten all connections to the recommended torque.Stop any fuel or oil leak as soon as it is discovered.Keep all exhaust manifold and turbocharger shields in place to reduce fire hazard.Collect drained liquids and wipe all oil, fuel or coolant spills.Store oily rags in proper containers. Do not leave rags on engine.Accumulated grease and oil on the engine is a fire hazard. Remove the grease, oil and debris at least every 1000 hours and each time any significant quantity of oil is spilled on the engine.Never store flammable liquids near the engine.Keep all lubricants stored in properly marked containers.Provide adequate and safe waste oil disposal.Oil and fuel filters must be properly installed and tightened when being changed.Diesel fuel and all lubricants are flammable. Do not weld on pipes or tubes that contain oil. Clean them thoroughly with nonflammable solvent before welding.Do not smoke while refueling.Loose or damaged lines or tubes that allow oil, fuel or coolant to leak can cause overheating and/or fire.Do not bend or strike high pressure lines. Do not install bent or damaged lines and tubes. Do not replace