WIRING GP-LADDER 3070277 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     9U-7072     Cap     1    
9U-7085 Cap     1    
9U-7086 Cap     1    
2P-9697 Plug     1    
6J-7366 Flared Cap     1    
9S-5518 Plug     1    
9L-8493 Cap     1    Start By:
Remove the engine oil filler. Refer to Disassembly and Assembly, "Engine Oil Filler - Remove and Install".Note: SERVICE DATA: TOOLING (A) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. The capacity of the cooling system is 47 L (12.4 US gal).
Illustration 1 g00918577
Remove fuel filter (1). Refer to Operation and Maintenance Manual, SEBU7477, "Fuel System Primary Filter - Clean/Inspect/Replace" for the correct procedure.
Remove bolt (2) and remove tube assembly (3) .
Illustration 2 g00918582
Remove hose assembly (4) from clip (5). Loosen bolt (6) and position bracket (7) out of the way.
Remove nuts (8). Remove bolts (9) and remove bracket (10) .
Illustration 3 g00918593
Disconnect hose assemblies (11). Disconnect tube assembly (12) and disconnect hose (13) .
Illustration 4 g00918597
Loosen bolt (14) and remove bolts (15) .
Illustration 5 g00918616
Attach a suitable lifting device to air compressor (16).
Remove bolt (14) and remove air compressor (16). The weight of air compressor (16) is approximately 30 kg (65 lb).