WIRING GP-GENERATOR 3482879 - Caterpillar

Verify that all of the components of the axle shaft are clean and free of foreign material prior to installation.
Inspect all components for wear and replace the components, if necessary.
Illustration 1 g00576146
Install clamp (6) to axle shaft (5). Note: Clamp (6) must be positioned 1295 5 mm (51.0 0.2 inch) from the outboard end of axle shaft (5).
Apply 7M-7456 Compound to the threads of socket head bolts (7). Install two socket head bolts (7) that hold clamp (6) to axle shaft (5).
Illustration 2 g00576151
Tighten two socket head bolts (7) to a torque of 30 5 N m (22 4 lb ft). Use a hammer and a punch to stake clamp (6) in order to prevent two socket head bolts (7) from loosening.
Illustration 3 g00704219
Position a lifting sling around axle shaft (5), as shown. Secure the lifting sling to a suitable hoist.
Install axle shaft (5) to wheel (1) by using the lifting sling and Tool (A). The weight of the left hand axle shaft (5) is 82 kg (181 lb). The weight of the right hand axle shaft is 67 kg (148 lb).
Illustration 4 g00704320
To avoid damage to the braking system, do not exceed 5447 kPa (790 psi) when applying pressure to release the parking brake.
Install Tooling (B) to the rear parking and secondary brake, as shown. Use Tooling (B) to release the parking brake.
Illustration 5 g00704216
Use the following procedure to determine the correct amount of shims (4) that need to be installed.
Illustration 6 g00704185
Install retainer (3) and six bolts (2) that are equally spaced on retainer (3). Do not install shims at this time. Tighten bolts (2) to a torque of 140 N m (105 lb ft).
Rotate wheel (1) by two complete revolutions. Tighten bolts (2) to a torque of 140 N m (105 lb ft).
Remove the torque from bolts (2). Tighten bolts (2) to a torque of 110 N m (81 lb ft).
Rotate wheel (1) by two complete revolutions. Tighten bolts (2) to a torque of 110 N m (81 lb ft).
Rotate wheel (1) by two complete revolutions. Tighten bolts (2) to a torque of 110 N m (81 lb ft).
Illustration 7 g00704433
Illustration 8 g00704216
Use Tool (C) to measure the distance from the outside of retainer (3) to the spindle. Use the two opposite holes in retainer (3) to perform the measurements. Average the two measurements and record this dimension.
Illustration 9 g00713886
Use Tool (D) to measure the thickness of retainer (3). Record this dimension.
Subtract the dimension that was recorded in Step 9.g from the dimension that was recorded in Step 9.f. Add 0.381 mm (0.0150 inch) to this dimension.
Remove bolts (2) and retainer (3). Install shims (4) that have a total thickness of the dimension that was determined in Step 9.h.
Install retainer (3). Apply 9S-3263 Thread Lock Compound to the threads of bolts (2).
Install bolts (2) that hold retainer (3) and shims (4) to the spindle. Tighten ten bolts (2) to a torque of 250 15 N m (185 11 lb ft). End By:
Install the final drive. Refer