WIRING GP-ELECTRONIC CONTROL 3590920 - Caterpillar

time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Oil Filter - Change
Fumes Disposal Filter Element - Replace
Overhaul Considerations
Throttle Control Valve - Check
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Control Panel - Inspect/Test
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel Filter Differential Pressure - Check
Fumes Disposal Filter Differential Pressure - Check
Walk-Around Inspection
Initial 250 Service Hours
Crankcase Pressure - Measure
Engine Oil Sample - Obtain
Every 250 Service Hours
Coolant Sample (Level 1) - Obtain
Initial 1000 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Valve Stem Projection - Measure/Record
Every 1000 Service Hours
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Crankcase Pressure - Measure
Crankshaft Vibration Damper - Inspect
Cylinder Pressure - Test/Record
Engine Crankcase Breather - Clean
Engine Valve Lash and Bridge - Check
Exhaust Piping - Check
Gas Pressure Regulator Condensation - Drain
Hoses and Clamps - Inspect/Replace
Ignition System Timing - Check/Adjust
Inlet Air System - Check
Nitrogen Oxide Sensor - Calibrate
Every 2000 Service Hours
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil - Change
Engine Oil Filter - Change
Every 3000 Service Hours
Spark Plugs - Inspect/Adjust/Replace
Every 4000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Compressor Bypass - Check
Crankcase Blowby - Test/Record
Driven Equipment - Check
Engine Protective Devices - Check
Exhaust Bypass - Inspect
Fuel Metering Valve - Check
Starting Motor - Inspect
Turbocharger - Inspect
Valve Stem Projection - Measure/Record
Water Pump - Inspect
Every 8000 Service Hours
Coolant Temperature Regulator - Replace
Fumes Disposal Filter Element - Replace
Between 10 000 and 20 000 Service Hours
Overhaul (Top End)
Every 24 000 Service Hours or 3 Years
Coolant (DEAC) - Change
Between 30 000 and 60 000 Service Hours
Overhaul (In-Frame)
Between 50 000 and 100 000 Service Hours
Overhaul (Major)