AVSPARE.COM
parts catalog

WIRING GP-HYDRAULIC TANK 3966962 - Caterpillar



3966962 WIRING GP-HYDRAULIC TANK Caterpillar parts 844K, 990K WIRING
Rating:
73
Alternative (cross code) number:
CA3966962
396-6962
3966962
Caterpillar 3966962 WIRING GP-HYDRAULIC TANK

Buy WIRING GP-HYDRAULIC TANK 3966962 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL DOZER, WHEEL LOADER,

Compatible equipment models: 3966962:

WHEEL DOZER  844K  
WHEEL LOADER  990K   Caterpillar
Number on catalog scheme:
 
  For full view, you need register

Information:


Illustration 1 g02149399
Schematic of the key readerThis diagnostic code is recorded when the Chassis ECM does not receive expected information from the key reader over the data link.Test Step 1. CHECK THE CAT ET SCREEN.
Check the Cat ET screen for a communication error between the Chassis ECM and the key reader.Note: The diagnostic code for the key reader is CID 1960 FMI 09.Expected Result:The Cat ET reports a diagnostic code of CID 1960 FMI 09 as being active.Results:
YES - The Cat ET reports a diagnostic code of CID 1960 FMI 09 as being active.Repair: Troubleshoot the connections for the Cat Data Link between the key reader and the Chassis ECM. Proceed to Test Step 3.
NO - The diagnostic code has NOT been logged or the diagnostic is NOT active. Proceed to Test Step 2.Test Step 2. CHECK FOR POWER TO THE KEY READER.
With the keyswitch in the ON position, check for system voltage between contact 3 and contact 4 of the key reader. Expected Result:The voltage that is measured is approximately system voltage.Results:
YES - The voltage that is measured is approximately system voltage. The voltage is correct. Proceed to Test Step 4.
NO - System voltage is NOT present. The wiring harness has failed.Repair: Check the wiring harness for signs of damage. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK THE WIRING HARNESS OF THE CAT DATA LINK FOR AN OPEN CIRCUIT.
Disconnect the J1 harness connector from the Chassis ECM.
On the side of the harness for the key reader, install a jumper wire between contact 3 and contact 4.
At the J1 harness connector for Chassis ECM, measure the resistance between J1-10 and J1-20 of the connector for the Chassis ECM.Expected Result:The resistance is less than 5 ohms.Results:
YES - The resistance is less than 5 ohms between pin 3 and pin 4. The wiring is correct. Proceed to Test Step 4.
NO - The resistance is greater than 5000 ohms between pin 3 and pin 4. The wiring for the Cat Data Link is not correct between the ECM and the key reader.Repair: Check the wiring harness for signs of damage. Repair the machine harness or replace the machine harness.STOPTest Step 4. CHECK THE WIRING HARNESS OF THE CAT DATA LINK FOR A SHORT TO GROUND.
The connector for the key reader and the

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
844K Wheel Dozer K4Y00001-UP (MACHINE) POWERED BY C27 Engine
844K Wheel Dozer M4R00001-UP (MACHINE) POWERED BY C27 Engine
990K Wheel Loader K9X00001-UP (MACHINE) POWERED BY C27 Engine
990K Wheel Loader M9P00001-UP (MACHINE) POWERED BY C27 Engine
844K Wheel Dozer MBE00001-UP (MACHINE) POWERED BY C27 Engine
844K Wheel Dozer KLS00001-UP (MACHINE) POWERED BY C27 Engine
990K Wheel Loader A9P00001-UP (MACHINE) POWERED BY C27 Engine
990K Wheel Loader DJK00001-UP (MACHINE) POWERED BY C27 Engine


Parts wiring Caterpillar catalog:

3325734 WIRING GP-SERVICE CENTER
844K, 854K, 990K, 992K, 993K
3470631 WIRING GP-UNIT INJECTOR
773G, 773G OEM, 775G, 775G OEM, 777G, 844K, 854K, 990K, 992K, 993K
3601635 WIRING GP-COMMUNICATION
844K, 854K, 990K, 992K, 993K, 994H
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.