WIRING GP-CAB 3987003 - Caterpillar

SIZE="-1">Illustration 8 g06152444
Remove two bolts (21) and remove shield (22).
Illustration 9 g06152450
Remove insulation (23).
Illustration 10 g06152452
Disconnect three swivel nuts (24) and remove four nuts (25).
Remove exhaust bypass valve (26).Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty.
A 2P-2333 Sealant -
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.
Illustration 11 g06152452
Position exhaust bypass valve (26).
If the studs for exhaust bypass valve (26) are installed, tighten to a torque of 35 5 N m (26 4 ft lb).
Apply Tooling (A) to the threads of the studs and to the mating face of the locknuts. Position the new gasket and exhaust bypass valve (26) on the exhaust elbow. Install new locknuts (25). Tighten locknuts (25) according to the following procedure.
Tighten two diagonal locknuts to a torque of 25 6 N m (18 4 lb ft).
Tighten the remaining locknuts to a torque of 25 6 N m (18 4 lb ft).
Tighten all four locknuts to a torque of 47 9 N m (35 7 lb ft).
Connect three swivel nuts (24).
Illustration 12 g06152450
Install insulation (23).
Illustration 13 g06152444
Position shield (22) and install two bolts (22).
Illustration 14 g06152304
Position shield (20) and install three bolts (19).
Illustration 15 g06152285
Position shield (18) and install 16 bolts (17). Ten bolts are not shown.
Illustration 16 g06152261
Position shield (16) and install 14 bolts (51). Five bolts are not shown.
Illustration 17 g06152245
Position shields (11), (12), and (13) and install 14 bolts (14). Two bolts are not shown.
Illustration 18 g06152213
Position shields (7), (8), and (10) and install 12 bolts (9).
Illustration 19 g06151954
Position shield (5) and install 13 bolts (6). One bolt is not shown.
Illustration 20 g06151917
Position shields (1), (3), and (4) and install 11 bolts (2).