WIRING GP- 4796254 - Caterpillar

Personal injury or death can result from sudden machine movement.Accidental movement of controls while the engine is running can cause sudden machine movement.Do not make any adjustments to the control linkage with the engine running unless required.Allow only approved personnel on the machine. Keep other personnel off the machine and in clear view of the service personnel.
Illustration 1 g00886916
Transmission Hydraulic Controls (1) Face of valve body (2) Spools (3) Nut (4) Rods (5) Bolt (6) Hole (7) Hex hole (8) Rod end (9) Nut (10) Detent (11) Cam (12) Bolts (13) Nut
Remove the cover from the hydraulic control linkage. Remove the cover from the control valve housing.
Tighten bolts (12) by hand in order to allow the block to slide back and forth.
Place detent assembly in fourth gear of cam (11) .
Center hole (6) around hex hole (7) .
Tighten bolts (12) .
Loosen nut (9) and remove bolt (5) .
Loosen nuts (3) and (13). Adjust rods (4) until spools (2) are even with face (1) of the valve body. Tighten nuts (3) and (13) .
Move the transmission control lever in the operator's compartment to the FOURTH speed position.
Adjust end (8) until bolt (5) can be installed in cam (11). Tighten nut (9) .
Install the covers.