WIRING GP 5386364 - Caterpillar

Illustration 28 g02728224
Install the new O-rings seals, speed sensors (24), and the bolts (25) .
Illustration 29 g02728346
Install planetary assembly (14). Install new O-ring seals (22) and (23) .Note: Lubricate the seal with lubricant that is being sealed prior to the installation of planetary assembly (14) .
Illustration 30 g02728352
Attach a suitable lifting device and Tooling (H) to housing assembly (16). The weight of housing assembly (16) is approximately 50 kg (110 lb). Position housing assembly (16) and install bolts (17) .
Illustration 31 g02728370
Lubricate plates (20) and disc (21) with SAE 30 oil. Install friction disc (21) and plates (20). Install new O-ring seals (11) and (12) .Note: Take care not to damage the bore of the housing assembly.
Illustration 32 g02728398
Install new seals (19) on to piston (18) .Note: Lightly lubricate seals (19) with oil being sealed.
Illustration 33 g02728414
Use Tooling (M) in order to install piston (18). Install piston (18). Remove Tooling (M) .Note: Take care not to damage the outer surface of piston (18) .
Illustration 34 g02728420
Illustration 35 g02728423
Side profile view
Install spring (13) .
Illustration 36 g02728430
Attach Tooling (H) and a suitable lifting device to housing assembly (6). The weight of housing assembly (6) is approximately 79 kg (175 lb).Note: Make sure that the brake shuttle valve is in position and installed correctly.
Position housing assembly (6) and install bolts (7). Tighten bolts (7) evenly in order to load spring pressure. Install Tooling (N) .
Illustration 37 g02729325
Install Tooling (P) and Tooling (G). Attach Tooling (R) to part (32). Attach an air supply hose to Tooling (R). Apply 34.5 kPa (5 psi). This procedure will test for leaks. Spray the steering side housing joints with soapy water to identify leaks.Note: Motor cables can have minor air leakage through the cables. The leakage can be seen at the lugs of the cables.
Illustration 38 g02729350
Remove plug (33). Attach Tooling (S). Apply 1380 kPa (200 psi). Ensure that the pressure does not drop for 5 minutes.
Release pressure. Remove Tooling (S). Install plug (33) .
Remove all Tooling, except for (A), (B), and applied sealants.
Illustration 39 g02727675
Attach Tooling (A) and a suitable lifting device to the electric drive propulsion module. The weight of the electric drive propulsion module is approximately 1225 kg (2700 lb).
Remove the electric drive propulsion module from Tooling (B) .
Install the electric drive propulsion module. Refer to Disassembly and Assembly, KENR5162, "Electric Drive Propulsion Module - Install".