WRENCH G- 1U5545 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01480192
Typical example
Slide locking tab (2) into the unlocked position.
Disconnect harness assembly (3) from inlet manifold pressure sensor (1).
Use a deep socket to remove inlet manifold pressure sensor (1).
Remove O-ring seal (4) from inlet manifold pressure sensor (1). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01480192
Typical example
Install a new O-ring seal (4) into the groove on inlet manifold pressure sensor (1).
Use a deep socket to install inlet manifold pressure sensor (1). Tighten the inlet manifold pressure sensor to a torque of 10 N m (89 lb in).
Connect harness assembly (3) to inlet manifold pressure sensor (1).
Slide locking tab (2) into the locked position.