WRENCH-CHAIN 1U8760 - Caterpillar

Monitor Procedure
The following procedure will allow the user to select one of the ten work tools that are programmed into the monitor and machine ECM.
The "Home" screen of the monitor is displayed when the key switch for the machine is turned to the ON position. Press the "Apps" key in lower left hand corner to display the main menu options.
Select "Bucket / Work Tool Select" menu.
Use the arrows to highlight the desired work tool from the "Bucket / Work Tool Select" menu. Press the OK key to select the work tool.Note: The selected work tool will now appear in the message bar at top of the monitor screen.The selected work tool will now appear at the bottom of the "Home" screen.Note: To change the parameters of the work tool, refer to Testing and Adjusting, "Work Tool Parameter - Program" for more information.Cat Electronic Technician Procedure
The following procedure will allow the user to select one of the ten work tools that are programmed into the machine ECM using Cat Electronic Technician.
Connect the Cat Electronic Technician to the diagnostic connector located behind the operator seat of the cab.
Start Cat Electronic Technician.
Illustration 1 g06246627
Select the ECM for "Implement Control".
Illustration 2 g06246668
Select "Tool Configuration" from the "Service" menu.
Illustration 3 g06246669
Work tool list (typical example)
Highlight the desired tool. Click on "Activate" in the bottom left corner of the screen. The selected tool will now be listed as the "Active Tool" at the top of the screen.Note: When changing the active work tool in Cat ET, the work tool will not be updated in the machine monitor until the machine has been turned off and restarted.Note: To change the parameters of the work tool, refer to Testing and Adjusting, "Work Tool Parameter - Program" for more information.