WRENCH 2488832 - Caterpillar

Truck Engines: 3126B (S/N: BKD1-UP; 1AJ1-UP; 5GL1-UP; 8YL1-UP; 7AS1-UP; 8SZ1-UP) 3126E (S/N: DPF1-UP; 6ZG1-UP; CKM1-UP; CRP1-UP; 9SZ1-UP)Introduction
The 240-0717 Engine Oil Lines Gp is available for repair of the high pressure oil line. The kit is used in order to replace the flexible high pressure oil line. The oil line is part of the Hydraulic Electronic Unit Injector Pump.Note: This kit includes two different spacers. 122-5855 Spacer has an outer diameter of 20 mm (0.79 inch) and a length of 26 mm (1.02 inch). 135-5096 Spacer has an outer diameter of 17 mm (0.67 inch) and a length of 16 mm (0.63 inch). Make sure that the correct spacer is used. Failure to use the correct mounting hardware and the correct installation procedure may result in failure of the Engine Oil Lines Gp.The 240-0717 Engine Oil Lines Gp is used on engine models with the following serial number prefixes (S/N: 1AJ; 5GL; 6ZG; 7AS; 8YL; 8SZ; 9SZ; BKD; CKM; CRP; DPF).
Table 1
Components in 240-0717 Engine Oil Lines Gp    
Callout     Part Number     Description     Quantity    
11     9M-1974     Washer     1    
13     122-5855     Spacer     1    
13     135-5096     Spacer     1    
10     8S-8820     Clip     1    
12     8C-5748     Bolt     1    
9     6V-8636     Connector     1    
17     6V-9001     Elbow     1    
15     214-7568     O-ring     2    
16     221-3494     O-ring     2    
14     241-3782     Tube assembly     1    
18     033-6028     O-ring     1    
19     123-3132     Backup ring     1    
20     033-6039     O-ring     1    Note: Engines that are equipped with a remotely mounted fuel filter base must use 122-5855 Spacer . A remotely mounted fuel filter base allows the oil lines and the spacer to be directly bolted to the inlet manifold cover. Refer to illustration 2. Discard the 135-5096 Spacer .Note: Engines that use the middle mounted