WRENCH- 3857874 - Caterpillar

Digital Input #1 - Digital input #1 is used for "Emergency Stop". The input must be wired to battery negative through an emergency stop switch. The input can be set to activate on an active high (normally closed contact) or an active low (normally open contact). If the operator wants to enable the "Reduced Power Mode", then the emergency stop must be configured for active low.ReferenceTesting and Adjusting , "Electronic Control Module (Generator Set) - Configure"Activating the emergency stop input will either cause the generator set to stop immediately or will prevent the generator set from starting. Once digital input #1 goes active, the engine will not start until the event is reset.ReferenceSystem Operation , "Event Resetting"Digital Input #2 - Digital input #2 is used for remotely starting and stopping the generator set. The input must be wired to battery negative through a "Remote Initiate" switch. The input can be set to activate on an active high (normally closed contact) or an active low (normally open contact). If the input is active, and the EMCP 3 is in the "AUTO" mode, then the engine will attempt to start and run. Once the input becomes inactive, the engine will enter into cool down (if programmed to do so) and will then stop.All remaining inputs can be configured.Function and Navigation Keys
ReferenceCall outs that are used in this section can be found on the EMCP 3 control panel in Systems Operation, "Electronic Control Module (Generator Set)".The keys listed below are used for programming the EMCP 3 and navigating within the menu structure.ReferenceRefer to Systems Operation, "Electronic Control Module (Generator Set)" for an explanation of the function keys and the navigation keys. The function keys include the enter and escape keys. The navigation keys include the scroll left, scroll right, scroll up, and scroll down) keys.Escape (9) - Used to navigate up (backward) through the menu structure and to back out of data entry screens during set point programming.Enter key (10) - Select a highlighted menu item or save a programmed value.Scroll Right key (11) - During numeric data entry, choose the digit to edit. During certain set point adjustments, select or deselect a check box.Scroll Down key (12) - Move down through the main menu or navigate within a list in order to highlight one of the items. Also used to decrement digits (0-9).Scroll Up key (13) - Move up through the main menu or navigate within a list in order to highlight one of the items. Also used to increment digits (0-9).Scroll Left key (14) - During numeric data entry, choose the digit to edit. During certain set point adjustments, select or deselect a check box.Programming the Active State of the Digital Input
ReferenceFor an example of programming a digital input for a fuel level switch, see Systems Operation, "Setpoint Programming".In order to program the "Active State" of the digital input, perform the following steps:
On the EMCP 3, navigate to the digital inputs menu as follows.
At the "MAIN MENU" use the