WRENCH (1/2" Opening) 8H8507 - Caterpillar

Introduction
Illustration 4 g03394167
Figure 1: Lifting Clamp AssemblyThe 426-5675 Lifting Clamp Assembly is used to safely and effectively lift the accumulators for 784, 785, 789, and 793 Off-highway trucks.Specifications
Table 1
Table 1
Part Numbers and Specifications of Lifting Clamp Assembly    
Lifting Device Part No/ Description     Part No/ Accumulator     Dimensions
(L x W x Thickness)     Weight    
426-5675 Lifting Clamp     348-9277 Accumulator Service Group     293.8 x 189.6 x 44.5 mm
(11.6 x 7.5 x 1.8 in)     3.5 kg (7.7 lb)    
426-5691 Lifting Clamp     253-4120 Accumulator Group 180-47(A)     339.4 x 235 x 44.5 mm
(13.4 x 9.3 x 1.8 in)     3.5 kg (7.7 lb)    
426-5702 Lifting Clamp     214-1736 Accumulator Bladder Group     350.4 x 246.1 x 44.5 mm
(13.8 x 9.7 x 1.8 in)     3.5 kg (7.7 lb)    Operation Section
Personal injury or death can result from lifting a heavy component.The heavy component can fall if using an incorrect hoist and/or sling or fastener to lift the load.Be sure the hoist and other devices have the correct lifting capacity to lift a heavy component. The approximate weight of the heavy component is given below.
Failure to comply to the rated load can cause possible personal injury or attachment damage.Review the rated load of a particular attachment before performing any operation. Make adjustments to the rated load as necessary.
Note: The lifting assembly should only be used with the appropriate accumulators as mentioned in Table 1. Ensure that the lifting clamp assemblies are fully assembled and that the bolts are NOT completely tightened before fitting the Accumulators.Once the appropriate location is marked, the tool should be bolted correctly in order to prevent it from slipping.The Working Load Limit (WLL) of the lifting clamp assemblies (423-5675, 426-5691, and 426-5702) are 625 kg (1378 lb). It is recommended NOT to use the tool assembly to lift more than the rated WLL.
Illustration 5 g03394191
Figure 2: The anchor point of the Lifting Clamp AssemblyNote: The operator should use appropriate lifting (hoist) mechanism to lift the tool and lift ONLY using the linking bracket anchor points as shown in Figure 2. For safety, it is recommended that the operator remain at a safe distance while the tool is in use.
Illustration 6 g03394204
Figure 3: Exploded View of the Components
Table 2
No     Part Name     Qty per Part No    
1     Steel Strap     2    
2     Support Plates     4    
3     Eyebolt Assembly (422-1782)     2    
WLL (all part numbers)     625 kg (1378 lb)    Inspection and Maintenance Section
Inspection
Inspect tooling prior to each use for damage, bending, nicks, burrs, dents, cracks, bent or worn parts. If damage is found, destroy the tool and dispose of as scrap. Replace damaged tool with new product.
Do not use unless the Working Load Limit (WLL) identification markings are legible.
Do not use if any holes are elongated or deformed.
Have the tool inspected annually by an approved dealership inspector.Cleaning
Clean the tooling using a non-solvent based cleaner.Storage
Store the tooling in a clean, dry location