YOKE GP 5215334 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1 Start By:
Remove the engine oil pan.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01144041
Use Tooling (A) to rotate the crankshaft in order to gain access to the piston cooling jet.
Remove bolt (1) and remove piston cooling jet (2). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01144041
Use Tooling (A) to rotate the crankshaft in order to gain access to the piston cooling jet. Note: Engine damage may occur if the piston cooling jet is not installed properly. Install the piston cooling jet by hand.
Position piston cooling jet (2) in the cylinder block. Ensure that piston cooling jet (2) is flush with the cylinder block. Install bolt (1). Tighten bolt (1) to a torque of 28 7 N m (21 5 lb ft). End By:
Install the engine oil pan.