YOKE 5J8976 - Caterpillar

Install valve bridges (6) to the valve stems.Note: Install used valve bridges in the original location and in the original orientation. Ensure that the valve bridges are correctly seated on the valves. New valve bridges may be installed in either orientation.
Illustration 2 g02004093
Clean the pushrods. Inspect the pushrods for wear and damage. Replace any pushrods that are worn or damaged.
Apply clean engine lubricating oil to both ends of pushrods (9) . Install the pushrods to the engine with the cup upward.Note: Ensure that the pushrods are installed in the original location and that the ball end of each pushrod is correctly seated in the valve lifters.
Illustration 3 g02085993
If necessary, use Tooling (A) in order to rotate the crankshaft so that number one piston is at top dead center on the compression stroke. Refer to System Operation, Testing and Adjusting, "Position the Valve Mechanism Before Maintenance Procedures" for the correct procedure. Install Tooling (B) through Hole (W) in order to lock the crankshaft.Note: Do not use excessive force to install Tooling (B) . Do not use Tooling (B) to hold the crankshaft during repairs.
Remove Tooling (B) .
Failure to ensure that the crankshaft is positioned at 60 degrees before or after top dead center will cause interference between the pistons and valves. Failure to ensure that the crankshaft is positioned at 60 degrees before or after top dead center will result in damage to the engine.
Use Tooling (A) in order to rotate the crankshaft to 60 degrees before or after top dead center.
Illustration 4 g02003035
Illustration 5 g02307257
Ensure that the rocker shaft assembly is clean and free from wear and damage.
Position the rockershaft assembly with Spotfaces (Y) for Torx screws (7) in the up ward position.
Install Tooling (E) to rocker shaft assembly.
Install Torx screws (7) to the rocker shaft.Note: Ensure that correct Torx screw (7) is installed to Position (X) .
Illustration 6 g02004078
Illustration 7 g02003036
Illustration 8 g02047334
Ensure that ALL threaded inserts are fully unscrewed.
Damage to the engine will occur if all threaded inserts are not fully unscrewed.
Position rocker shaft assembly (8) onto the cylinder head. The retaining clip (10) should face the front of the engine.Note: Ensure that the threaded inserts are correctly seated in ends of pushrods (9) .
Use Tooling (D) in order to tighten Torx screws (7) hand tight.
Remove Tooling (E) from the rocker shaft. Install the remaining Torx screws (7) to the rocker shaft. Tighten the Torx screws (7) hand tight.
Tighten the Torx screws to a torque of 35 N m (26 lb ft) in the numerical sequence that is shown in Illustration 8.
Ensure that valve bridges (6) are correctly located on the valve stems.
Illustration 9 g01992077
Ensure that guides (5) for the pushrods are correctly positioned on threaded inserts (4) . Use Tooling (C) in order to tighten threaded inserts (4) on all the rocker arms. Tighten the threaded inserts to a torque of 30 N m (265 lb in).Note: When the threaded insert is tightened, the threaded insert must seat correctly into the cup for the pushrod.
Illustration 10 g01992076
Install a new O-ring seal (1) to plug