YOKE AS 7T4007 - Caterpillar

Cleaning Primary Elements
Do not clean the filter elements by bumping or tapping them. Do not use filter elements with damaged pleats, gaskets or seals. Engine damage can result.Make sure the cleaned filter elements are completely dry before installing into the filter housing. Water remaining in the elements can cause false indications of contamination in Scheduled Oil Sampling test results.
Filter elements can be cleaned with pressure air - 205 kPa (30 psi) maximum, pressure water - 280 kPa (40 psi) maximum, or detergent washing. 1. Direct air or water along the pleats inside and outside of filter element.The element can be washed in warm water and nonsudsing household detergent. Rinse inside and outside the pleats and air dry fully.2. Inspect the filter elements after cleaning. Do not use a filter element with damaged pleats, gaskets or seals.3. Wrap and store the clean filter elements in a clean, dry place.Ether Starting Aid (If Equipped)
Installing the Cylinder
1. Open the right engine access cover on the rear of the machine. The ether cylinder is mounted to the front of the compartment. 2. Loosen the cylinder retaining clamp, unscrew and remove the empty ether cylinder.3. Remove the used gasket. Install the new gasket provided with each new cylinder.4. Install the new cylinder. Tighten the cylinder hand tight. Tighten the cylinder clamp securely.5. Close the access door.Fuses and Circuit Breakers
Replace Fuses
Fuses - They protect the electrical system from damage caused by overloaded circuits. Change a fuse if the element separates. If the element of a new fuse separates, have the circuit checked and repaired.
Replace the fuses with the same type and size only. Otherwise, electrical damage can result.If it is necessary to replace fuses frequently, an electrical problem may exist. Contact your Caterpillar dealer.
The fuse panel is located on the console at the right side of the cab. Battery (1) - 10 amps. Blank (2) Windshield Wiper (3) - 10 amps. Transmission Neutralizer (4) - 10 amps. Beacon/Load check (5) - 10 amps. Ride Control/Diverter Valve (6) - 10 amps. Electronic Monitoring System (7) - 10 amps. Front Cab Flood Lights (8) - 10 amps. Rear Flood Lights (9) - 10 amps. Lighter (10) - 10 amps. Transmission Autoshift (11) - 10 amps. Bucket Kickout (12) - 10 amps.Reset Circuit Breakers
Circuit Breaker Reset - Push the button in to reset the