YOKE 8K0116 - Caterpillar

Problems with the electronic control system are reported via these types of codes: flash codes, SPN/FMI codes, diagnostic codes, and event codes.For information on flash codes, refer to Troubleshooting, "Flash Codes".For information on SPN/FMI codes, refer to Troubleshooting, "Diagnostic Codes".For information on diagnostic codes, refer to Troubleshooting, "Diagnostic Codes".For information on event codes, refer to Troubleshooting, "Event Codes".Use Table 1 as a cross-reference between the various types of codes.Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.
Table 1
Cross Reference for Diagnostic Codes
Flash Code SPN(1)/FMI Code Diagnostic Code
or
Event Code Description of Code
N/A 1387-15 E443(2) High Auxiliary Pressure Warning
1387-16 High Auxiliary Pressure Derate
1387-00 High Auxiliary Pressure Shutdown
441-15 E445(2) High Auxiliary Temperature Warning
441-16 High Auxiliary Temperature Derate
441-00 High Auxiliary Temperature Shutdown
626-05 2417-05 Ether Injection Control Solenoid current low
626-06 2417-06 Ether Injection Control Solenoid current high
1387-03 1835-03 Auxiliary Pressure Sensor open/short to +batt
1387-04 1835-04 Auxiliary Pressure Sensor short to ground
441-03 1836-03 Auxiliary Temperature Sensor open/short to +batt
441-04 1836-04 Auxiliary Temperature Sensor short to ground
111-02 111-02 Engine Coolant Level Sensor Loss of Signal
13 174-03 174-03 Fuel Temperature open/short to +batt
174-04 174-04 Fuel Temperature short to ground
21 678-03 41-03 8 Volt DC Supply short to +batt
678-04 41-04 8 Volt DC Supply short to ground
620-03 262-03 5 Volt Sensor DC Power Supply short to +batt
1079-03
620-04 262-04 5 Volt Sensor DC Power Supply short to ground
1079-04
24 100-03 100-03 Engine Oil Pressure open/short to +batt
100-04 100-04 Engine Oil Pressure short to ground
100-10 100-10 Engine Oil Pressure abnormal rate of change
25 102-03 102-03 Boost Pressure Sensor short to +batt
1785-03 Intake Manifold Pressure Sensor voltage high
102-04 102-04 Boost Pressure Sensor short to ground
1785-04 Intake Manifold Pressure Sensor voltage low
102-10 102-10 Boost Pressure Sensor abnormal rate of change
1785-10 Intake Manifold Pressure Sensor abnormal rate of change
26 108-03 274-03 Atmospheric Pressure open/short to +batt
108-04 274-04 Atmospheric Pressure short to ground
27 110-03 110-03 Engine Coolant Temperature open/short to +batt
110-04 110-04 Engine Coolant Temperature short to ground
28 91-13 91-13 Throttle Position calibration required
32 91-08 91-08 Throttle Position signal abnormal
34 190-08 190-08 Engine Speed signal abnormal
723-08 342-08 Secondary Engine Speed signal abnormal
35 190-15 E362(2) Engine Overspeed Warning
190-00 Engine Overspeed Shutdown
37 94-03 94-03 Fuel Pressure open/short to +batt
94-04 94-04 Fuel Pressure short to ground
38 105-03 172-03 Intake Manifold Air Temp open/short to +batt
105-04 172-04 Intake Manifold Air Temp short to ground
42 637-13 261-13 Engine Timing calibration required
46 100-17 E360(2) Low Engine Oil Pressure Warning
100-18 Low Engine Oil Pressure Derate
100-01 Low Engine Oil Pressure Shutdown
51 168-00 168-00 System Voltage high
168-01 168-01 System Voltage low
168-02 168-02 System Voltage intermittent/erratic
56 630-02 268-02 Check Programmable Parameters
631-02 253-02 Personality Module mismatch
58 639-09 247-09 J1939 Data Link communications
61 110-15 E361(2) High Engine Coolant Temperature Warning
110-16 High Engine Coolant Temperature Derate
110-00 High Engine Coolant Temperature Shutdown
62 111-17 E2143(2) Low Engine Coolant Level Warning
111-18 Low Engine Coolant Level Derate
111-01 Low Engine