YOKE AS 8Y0035 - Caterpillar

Note: For an updated selection of the programmable parameters, refer to Special Instruction, REHS2884, "Application and Installation Guide".
Table 1
Parameter Available Range/Options Default
Equipment Identification Parameters
Engine Serial Number 18 characters Not Programmed
Vehicle ID 18 characters Not Programmed
Transmission Serial Number N/A Factory Programmed
Torque Converter Serial Number N/A Factory Programmed
Vehicle Speed Parameters
Top Ground Speed 0-139 MPH 139
Transmission Output Shaft Configuration 0-5000 rev/Km 0
Transmission PTO Configuration Parameters
PTO Neutral Restriction Disabled, Enabled Disabled
PTO Mode Enable Status Disabled or Enabled Disabled
PTO Mode Gear Limit Not Configured, Gear 1, Gear 2, Gear 3, Gear 4, Gear 5, Gear 6, Gear 7, Gear 8 Not Configured
PTO Mode Maximum Engine Speed For Engagement 0 - 5000 RPM 0
PTO Mode Maximum Engine Speed For Operation 600 - 3500 RPM 0
PTO Mode Maximum Transmission Output Speed For Engagement 0 - 8000 RPM 0
PTO Mode Maximum Transmission Output Speed for Operation 0 - 8000 RPM 0
Driveline PTO Configuration Parameters
Driveline PTO Minimum Engine Speed for Latching 500 - 3000 RPM 0
Driveline PTO Minimum Engine Speed for Torque Converter Lockup 600 - 3000 RPM 1000
Driveline PTO Latching Enabled Status Disabled, Enabled Disabled
Driveline PTO Inertia Brake Enabled Status Enabled, Disabled Enabled
Driveline PTO Pump Shift Assist Enabled Status Disabled , Enable Disabled
Driveline PTO Mode Enabled Gear Configuration Disabled Gear 3, Gear 4, Gear 5, Gear 6, Gear 7, Gear 8 Disabled
Vehicle Configuration Parameters
Governed Engine Speed 1800 - 3500 RPM 2100
Peak Torque Engine Speed 1000 - 2500 RPM 1000
Transmission Output Shaft Torque Limit Configuration 0 - 48336 lb-ft 48336
Auto Neutral Function Enabled Status Disabled, Enabled Disabled
Auto Neutral Gear Reengagement Brake Required Configurat