YOKE 9G0925 - Caterpillar

Illustration 1 g03371292
Transmission Clutch Solenoid Valves
(1) Transmission solenoid valve (No. 8)
(2) Transmission solenoid valve (No. 7)
(3) Transmission solenoid valve (No. 5)
(4) Transmission solenoid valve (No. 6)
(5) Transmission solenoid valve (No. 3)
(6) Transmission solenoid valve (No. 4)
(7) Transmission solenoid valve (No. 1)
(8) Transmission solenoid valve (No. 2)
Illustration 2 g03367252
Connections of "Transmission Solenoid 5"
This diagnostic code is associated with the "Transmission Solenoid 5". The FMI 05 diagnostic code means that the Transmission ECM has determined that the current for the solenoid circuit is below normal.Some possible causes of this diagnostic code are listed below:
The energize circuit of the solenoid is open.
The return circuit of the solenoid is open.
The solenoid has failed.
The ECM has failed. This situation is unlikely. Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, that all connections are secure and that all connections are in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected.Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).Test Step 1. CHECK THE SOLENOID
Disconnect the solenoid from the machine harness.
At the machine harness connector for the solenoid, place a jumper wire from contact 1 (wire 755-OR(Orange)) to contact 2 (wire 922-BR(Brown)).
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the CID 1405 FMI 05 diagnostic code. Expected Result:The active diagnostic code changes from an FMI 05 to an FMI 06 diagnostic code when the jumper wire is installed.Results:
YES - The active diagnostic code changes from an FMI 05 to an FMI 06 diagnostic code when the jumper wire is installed. The solenoid has failed.Repair: The solenoid has failed. Repeat this Test Step "CHECK THE SOLENOID" to verify the solenoid failure. Replace the solenoid. Verify that the new solenoid corrects the problem.STOP
NO - The CID 1405 FMI 05 diagnostic code remains active. The jumper wire does not affect the status of the diagnostic code. The solenoid is not causing the problem. Proceed